SMOK TFV8 RBA Coil (Standard Version, 0.16ohm)
SMOK TFV8 RBA Coil, is the special Coil base for SMOK TFV8 tank, master DIY piece for TFV8 RBA vaping! It is almost compatible with all resistance value clapton coils and you can DIY easily. Large build deck and premade 0.16ohm/ 0.28ohm clapton coil for your selection.
It comes with
- 1 x SMOK TFV8 RBA Coil
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.
1. large deck and airflow, suitable for all types of material wire, brings you unique vaping experience
2. Turbo: 4.0T-X
3. Pre-installed: Patented Fused
4. Clapton Dual Coils 0.28Ω (50W-140W)/ Octuple core Fused Clapton coil 0.16Ω (40-100W)
How to replace the coil unit/coil head
How to build the RBA:
1. before, please make sure your hands are clean;
2. take RBA apart;
3. install and position the pre-wrapped coil: place the coil between the posts and wrap the ends around the screws and tighten up, make sure the coil is fined in the center and lined up with the air hole and also make sure the coil is not touching the base;
4. cutting the ends of wire off;
5. cut a strip of cotton and make sure it's not too much or too less;
6. insert the cotton, and placing it in the middle;
7. cutting the cotton at an angle and make sure it's not too short or too long.
8. wet the coil with your liquid and adjust the cotton.